The Worst Cup Ever Made

This is my entry for the Worst Cup Challenge. It uses multiple openings to allow the water to spill if the user doesn't know the trick. I made it with a single wall design so it would print faster. If you have a program like simplify 3D, set the infill at 100% for the bottom 2 inches, then lower it to about 15% for the rest of the print. This is so that it holds the water better. It may look crude because of the curvature of it but it is supposed to, after all it is the worst cup ever. The star shaped thing in the center is supposed to cave in, by doing this it breaks up the water as someone goes to drink, making it go everywhere. Fill it through the hole at the very top. The trick to drink from it is the straw leading up to one of the holes. Enjoy!