GY-61 ADXL335 Triple Axis...
This is a very low cost break out module for the ADXL335 tripple axis accelerometer. This...
This 5mW laser module emits a small intense focused beam of visible red light. The example provided below shows how the module can be used with an Arduino and photo resistor module (available here) to perform basic remote signaling.
This 5mW laser module emits a small intense focused beam of visible red light. The example provided below shows how the module can be used with an Arduino and photo resistor module (available here) to perform basic remote signaling.
Warning: This is a low power laser device, however as with all laser devices care should be taken when in use. You should never look directly in to its beam or point the laser at another person. Doing so may cause permanent eye damage. This item is not suitable for children.
Item Code: HCMODU0104
Operating voltage: 5V
Max Current (Laser on): ~30mA
PINOUT
Pin 1 (-) 5V
Pin 2 Not connected
Pin 3 (S) GND
This module can be purchased here.
Example Arduino sketches available on our support forum here.
This is a very low cost break out module for the ADXL335 tripple axis accelerometer. This...
The TSL2561 (HCARDU0102) Luminosity sensor module is a light to digital interface module. The...
This sensor accepts a GND and +5V supply, and has a single digital output which goes low (GND)...
This water sensor is designed for water detection and can be widely used in sensing rainfall...
The perfect accompaniment to our Pyroelectric Infrared PIR Motion Sensor Detector Module...
- Photosensitive diode
- Working power: + 5V
- Working current: < 10mA
-...
An excellent little module for detecting the speed of a motor. Ideal for our 2- and 4-wheeled...
On-board ACS712T ELC-05B current sensor; Working voltage: DC 5V; Power LED indicator; Measures...
A capacitive touch sensor module based on the dedicated TTP223 touch sensor IC. The module...
The VL53L0X (HCMODU0127) is a new generation Time-of-Flight (ToF) laser-ranging module housed...
This water level sensor / float switch can be used to sense when a liquid has reached a set...