A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S H-bridge driver IC's to allow either one stepper or two DC motors to be independently controlled. The module can accept a supply voltage between 2.5 to 12V allowing for motors within this supply...
A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S H-bridge driver IC's to allow either one stepper or two DC motors to be independently controlled. The module can accept a supply voltage between 2.5 to 12V allowing for motors within this supply range to be controlled safely from a standard microcontroller. Maximum drive current is 800mA. 0.1" pitch header pins allow for direct connection to a microcontoller such as an Arduino requiring just two digital pins per DC motor for control in both directions. Screw terminal blocks provide convenient connection to the motors(s).
- Dual L9110S chipset motor driver
- Input voltage: 2.5V~12V
- Current: 800mA
- Can drive two DC motors, and a 4-wire 2-phase stepper motor
This pulse generator module is intended to be interfaced with common types of stepper / motor...
The mLink 12-Channel Servo Controller allows you to independently control up to 12 servos per...
This is a square wave pulse generator module based on the ubiquitous NE555 timer IC. The...
This EasyDriver compatible stepper motor driver module utilises the Allegro A3967SLB...
This module (HCMODU0097) is a breakout board for the NXP PCA9685 16 channel PWM controller. It...
This item (HC3DPR0038) is a breakout out / adapter board for the low cost A4988 stepper motor...
The L298N motor drive module (HCROBO0068) contains a dual channel full H-bridge driver. This...
This module is based upon the HR4988 stepper motor driver and is ideal for use in 3D printer,...
This little module (HCMODU0083) is a breakout board for the IFR520 MOSFET transistor. The...
Uses ST' L298N chip, can directly drive two 3-30V DC motor, and provide a 5V output interface,...
A very compact dual channel H-bridge motor driver module. The module incorporates two L9110S H-bridge driver IC's to allow either one stepper or two DC motors to be independently controlled. The module can accept a supply voltage between 2.5 to 12V allowing for motors within this supply...