Operating LED by push button

Operating two serial connected led's using Push Button and BOLT WIFI MODULE along with Resistors

BeginnerFull instructions provided1 hour432

Things used in this project

Hardware components

5 mm LED: Red

LED-Light Emitting Diode is a Semi-conductor light source emits lights when current flows through it.

Resistor 1k ohm

Resistors are passive electrical components with two terminals that are used for either limiting or regulating the flow of electric current in electrical circuits.

Switch Actuator, APEM A01 series Illuminated Push-Button Switches

A Push Button switch is a type of switch which consists of a simple electric mechanism or air switch mechanism to turn something on or off.

Bolt IoT Bolt WiFi Module

USB-A to Mini-USB Cable

Software apps and online services

Bolt IoT Android App

Story

Hardware Connections

1. Connect 3volts of BOLT WIFI MODULE to one end of Switch.

2. Connect another end of Switch to one end of Resistor.

3. Connect Resistor another end to + ve pin of first LED.

4. Connect - ve pin of first LED to +ve pin of the second LED.

5. Connect - ve pin of the second LED to GND pin of BOLT WIFI MODULE.

How to connect to bolt cloud:

6. Go to the cloud.boltiot.com.

7. Go to the products and choose +add product then enter all the details as shown below.

8. Now click on the link icon on the top right corner then choose the device to get linked.

9. Once the device gets linked configure the product where you can view device and its status.

10.Now setting up the product once hardware setup is done connect the module with usb cable , select analog pin A0 and name as light .

Credits

Sai Lakshmi

1 project • 0 followers

Operating LED by push button