pluseometer

#define USE_ARDUINO_INTERRUPTS true    // Set-up low-level interrupts for most acurate BPM math.
#include <PulseSensorPlayground.h>     // Includes the PulseSensorPlayground Library.   

//  Variables
const int PulseWire = 0;       // PulseSensor PURPLE WIRE connected to ANALOG PIN 0
const int LED = 13;          // The on-board Arduino LED, close to PIN 13.
int Threshold = 550;           // Determine which Signal to "count as a beat" and which to ignore.
                               // Use the "Gettting Started Project" to fine-tune Threshold Value beyond default setting.
                               // Otherwise leave the default "550" value. 
                               
PulseSensorPlayground pulseSensor;  // Creates an instance of the PulseSensorPlayground object called "pulseSensor"


void setup() {   

  Serial.begin(9600);          // For Serial Monitor

  // Configure the PulseSensor object, by assigning our variables to it. 
  pulseSensor.analogInput(PulseWire);   
  pulseSensor.setThreshold(Threshold);   

  // Double-check the "pulseSensor" object was created and "began" seeing a signal. 
   if (pulseSensor.begin()) {
    Serial.println("We created a pulseSensor Object !");  //This prints one time at Arduino power-up,  or on Arduino reset.  
  }
}



void loop() {

 int myBPM = pulseSensor.getBeatsPerMinute();  // Calls function on our pulseSensor object that returns BPM as an "int".
                                               // "myBPM" hold this BPM value now. 

if (pulseSensor.sawStartOfBeat()) {            // Constantly test to see if "a beat happened". 
 Serial.println("  A HeartBeat Happened ! "); // If test is "true", print a message "a heartbeat happened".
 Serial.print("BPM: ");                        // Print phrase "BPM: " 
 Serial.println(myBPM);                        // Print the value inside of myBPM. 
}

if(myBPM >= 101){
  digitalWrite(LED, HIGH);
}

if(myBPM <= 59){
  digitalWrite(LED, HIGH);
}

  delay(20);                    
}