The Super Mini ITX Build - UDOO BOLT

Introduction

Ciao Guys!

In this tutorial we will create a SUPER Mini ITX Build with The Most Powerful Maker Board Ever and Nvidia GeForce RTX 2080Ti.

Step 1 - UDOO BOLT SETUP

Open the case

Remove the Power supply cover from the case

Take UDOO BOLT with the RAM already mounted

Optional: Mount the Wifi /BT Adapter in the lower M.2 slot and screw it in place

Take the M.2 key M to PCI-E X4 Adapter and connect it to the PCI-E Flat Riser

Connect the M.2 to PCI-E X4 Adapter in the NVMe slot of the UDOO BOLT and screw it in

Take the M.2 SSD and connect it into the last M.2 slot available on the UDOO BOLT

Take the 3D Printed Support with spacers at least 1 cm and screw the UDOO BOLT on it.

Step 2 - MINIITX CASE SETUP

Take the Power Supply cover we removed in the Step 1 and screw it on the Power Supply

Mount the UDOO BOLT into the Case using the 3D Printed Support putting the HDMI and Ethernet side on the back of the Case

Take the PCI-E 90° Riser and connect the Nvidia GeForce RTX 2080Ti

Take the Nvidia GeForce RTX 2080Ti and put it inside the case connecting the PCI-E 90° Riser to PCI-E riser coming from the UDOO BOLT

Screw in the Nvidia GeForce RTX 2080Ti in the Case

Optional: If you want some extra storage you can connect a SSD 2.5" SATA3 into the case

Take the Power Supply and mount it into case

Bridge the 2 pin of the 24 pins Power Connector to jump the Power Supply.

Connect the Power Cable to the M.2 to PCI-E adapter

Connect 2 Power Cables to Nvidia GeForce RTX 2080Ti

Optional: If you want to connect the Front Panel of the case on the UDOO BOLT you can read the dedicated section on the User Manual (page 33)

You can now close the lead of the case

Connect the Power Cable to 750 W Power Supply

Connect the 19V 65W AC Power Adapter to UDOO BOLT

Optional: If you want a single PSU you can use a "DC/DC 12V Step Up to 19V" to power UDOO BOLT with the 750W Power Supply.

Enjoy your new SUPER Mini ITX Build!