Final Finished Project: Remote Controlled Vehicle - 12/17/15

// This version uses call-backs on the event and RX so there's no data handling in the main loop!

#include <SPI.h>
#include "Adafruit_BLE_UART.h"

#define ADAFRUITBLE_REQ 10
#define ADAFRUITBLE_RDY 2
#define ADAFRUITBLE_RST 9

Adafruit_BLE_UART uart = Adafruit_BLE_UART(ADAFRUITBLE_REQ, ADAFRUITBLE_RDY, ADAFRUITBLE_RST);

boolean messageReceived = false;
uint8_t message[20];
int counter = 0; 



/**************************************************************************/
/*!
    This function is called whenever select ACI events happen
*/
/**************************************************************************/
void aciCallback(aci_evt_opcode_t event)
{
  switch(event)
  {
    case ACI_EVT_DEVICE_STARTED:
      Serial.println(F("Advertising started"));
      break;
    case ACI_EVT_CONNECTED:
      Serial.println(F("Connected!"));
      break;
    case ACI_EVT_DISCONNECTED:
      Serial.println(F("Disconnected or advertising timed out"));
      break;
    default:
      break;
  }
}

/**************************************************************************/
/*!
    This function is called whenever data arrives on the RX channel
*/
/**************************************************************************/
void rxCallback(uint8_t *buffer, uint8_t len)
{
  Serial.print(F("Received "));
  Serial.print(len);
  Serial.println(F(" bytes: "));
//  for(int i=0; i<len; i++)
//   Serial.print((char)buffer[i]); 
//
//  Serial.print(F(" ["));
//
//  for(int i=0; i<len; i++)
//  {
//    Serial.print(" 0x"); Serial.print((char)buffer[i], HEX); 
//  }
//  Serial.println(F(" ]"));

    switch(buffer[2]) {
      case 53:
        Serial.println ("up");
        digitalWrite(7, HIGH);
        counter = counter + 1; 
        delay (100);
        if (counter == 2){
          digitalWrite(7, LOW);
          counter = 0; 
        }
        break;
      case 54:
        Serial.println ("down");
        digitalWrite(6, HIGH);
        delay (100);
        digitalWrite(6, LOW);
        break;
      case 55:
        Serial.println ("left");
        break;
      case 56:
        Serial.println ("right");
        break;
    }
  
//  /* Echo the same data back! */
//  uart.write(buffer, len);
}

/**************************************************************************/
/*!
    Configure the Arduino and start advertising with the radio
*/
/**************************************************************************/
void setup(void)
{ 
  Serial.begin(9600);
  while(!Serial); // Leonardo/Micro should wait for serial init
  Serial.println(F("Adafruit Bluefruit Low Energy nRF8001 Callback Echo demo"));

  uart.setRXcallback(rxCallback);
  uart.setACIcallback(aciCallback);
  // uart.setDeviceName("NEWNAME"); /* 7 characters max! */
  uart.begin();
  pinMode(6, OUTPUT);
  pinMode(7, OUTPUT);
}

/**************************************************************************/
/*!
    Constantly checks for new events on the nRF8001
*/
/**************************************************************************/


void loop()
{
  uart.pollACI();
  
}