A battery charger circuit for charging any kind of 12v battery
The PowerPulse Inverter converts 12V DC to AC voltage using square wave pulses, offering modular design for easy troubleshooting and upgrade
Made a bench PSU from scratch using the ZK-4KX DC-DC Buck Boost module and a 3D-printed body.
Only bench power supply you will ever need. Two 10 amp 1 - 30 volt outputs, with 20 watt Pos/Neg Dual Supply 3-30 volts.
There are a lot of DIY options available, but because these batteries work at lower voltage (1.2V) there is not any specific method.
A power supply that can deliver 100w from a fast charger the best and smallest possible solution for lab bench supply.
Made a small PD 5V Buck Module for powering high-power devices like the Pi5, Latte Panda, etc. PD Output between 3V to 12V.
A portable, rechargeable breadboard power supply with adjustable 4-24V DC output, controlled by the RP2040 and powred by a 2000 mAh battery
It is easy to set up the power supply for the bread-board with a USB PD. The output voltage is from 3.3V to 20V.
This project evaluates the low cost ZK-PP2K High Power PWM & Pulse Signal Generator module
Get whatever voltage you want directly out of your modern USB-C charger. Even up to 5A.
The requirement of stable DC power supplies in the IOT applications and in electronics designed products is very versatile.
A variable power supply is incredibly useful in electronics projects, allowing you to fine-tune voltage to meet your circuit’s requirements.
A bench power supply with constant voltage and constant current modes using all off-the-shelf components
A 3D printed bench power supply with constant voltage and constant current modes.
DIY DC Motor Speed Controller Making at Home || 12V Fan Speed Controller
A power supply with battery charger, Booster circuit, Minimal design, Easy to use I/O and with different voltage output modes. Let's build
Transform old gaming power supplies into versatile, cost-effective variable power units for your DIY projects.
Charge your LiPos with this sakura-shaped USB charger based on the Renesas ISL9205IRZ chip. 🌸
A home automation project using a servo and temperature sensor to determine when to open and close a window automatically.
Currently on the WE MARS student design team we have the goal of pushing the boundaries on the hardware we implement.
Charge your APPLE pencil anytime anywhere this small pocket charger. Plug and charge! With onboard charge control, boost and charge detect.
Explore our online simulation of the Simple Push-Pull Follower—a hands-on project showcasing key concepts in electronic circuits.
