The measured voltage is up to 60V, and the measured current is up to 30A. The device is based on the Renesas DA14585 SoC
During the smoothing capacitor charging at SMPS switch on, a PTC protects a circuit against over current
The project describes how to build a 1x3 flip-disc display and how to control it via Arduino.
This project evaluates the low cost ZK-PP2K High Power PWM & Pulse Signal Generator module
The project is about how to convert 240V AC input power to 1.5V DC output power for your application.
The project describes how to build a 1x7 flip-disc display and how to control it via Arduino.
On&Off Button and 6v Coin Cell Batteries Power Supply for Arduino Nano by Circle Electronic
Let's design a TLF for LED bulb driver circuit and for microcontroller separately. Get all the design calculation from here and DIY custom.
Problem You need to select a power supply for your Raspberry Pi. Solution see
A battery charging module to charge 1s/2s cells, based on buck phenomenon.
Use the nPM1100 EK and an nRF52840 to create a BLE project that can be easily charged and powered efficiently.
A backup power supply is a circuit that supplies power to devices in case their main power supply goes down.
Get whatever voltage you want directly out of your modern USB-C charger. Even up to 5A.
let's make
This is a charging station with many features like you can charge 10 cells at a time and also you can check each battery's voltage
Open-source USB Type C PD board for 1S Lipo or Li-ion cell or cell with similar chemistry.
I made this IP2312 based module which has same form factor as the popular TP4056 one.
Using the Lora E5 Mini, create a device to determine where the best sun is actually located.
The requirement of stable DC power supplies in the IOT applications and in electronics designed products is very versatile.
A variable power supply is incredibly useful in electronics projects, allowing you to fine-tune voltage to meet your circuit’s requirements.
A review of the DC to DC Automatic Boost Buck Converter from ICStation.
The main aim of this article is to provide a guide on how to design an essential +/- 9V dual power supply.
UCR RoboSub is a entirely student run project, where the goal is to build a autonomous sub to compete in the RoboSub Competition!
We have developed a portable programmable power supply powered by USB type-c, which base on microython.
