This project will show you how to make a RC Car using 433MHz modules and L298N.
This project is about an Arduino Library to control the BK1086 and BK1088 devices. It was based on "BK1086/88E BROADCAST AM/FM/SW/LW RADIO R
A HAT Turning any 40-pin Raspberry Pi into a dual-channel Software-Defined-Radio (SDR)
I needed a small amp so I decided to repurpose an old car stereo that had been collecting dust in the basement.
This project will show you how to make an Arduino submarine.
This time I will present you a way to make a portable DSP radio with this module controlled by an ESP32 microcontroller.
An old GRUNDIG RTV500 AM-FM receiver turned into a webradio with their originals features.
An economic FM radio with WiFi connectivity incorporating cloud and IoT practices.
With this project, we want to create a new platform for communication.
Investigate how the signal strength from Iridium satellites correlates to the actual positions of Iridium satellites passing overhead.
Adapting Adafruit's CircuitPython to use the RFM69HCW Radio FeatherWing on the Zynq-7000 series FPGAs.
A simple radio communication experiment between 2 BBC Micro:bit boards, which can transmit and receive commands to/from each other.
This project will show you how to make a Bionic Hand Controller.
Take advantage of the Ultra96 by adding your own web applications.
This is a Windows 10 IoT Core project on the Raspberry Pi 2/3, coded by C#. You can use this module to build your own radio station.
Setting up a LoRa peer-2-peer communication by using CY8CKIT-062-BLE with Arduino Shield (Dragino LoRa, RFM95W).
Start converging between microcontroller dev boards and FPGA dev boards by running Adafruit's CircuitPython on the Zynqberry for the PiOLED.
A practical circuit of NRF24l01 that works well with any type of Arduino. Let's build own NRF to know connection setup.
Portable FM-Radio receiver using Arduino Nano Every and TEA5767.
Use two 915MHz radios to send/receive current environmental information and display it in real-time up to 350 meters away!
A tiny homemade radio telescope I built which can take pictures IN RADIO.
In this project, I am going to demonstrate how to make a small game that will show you which of the four players pressed the finger first
Getting started with LoRaWAN for Cypress PSoC 6 MCU based on LMiC to access to LoRaWAN TTN (The Things Network) using Dragino LoRa, RFM95W.
122 GHz is an amateur radio band. We need rigs! 3D-printed antennas are a great way to prototype new microwave band designs.
