The era of stick computers is back, Introducing Tomu, the super smart stick, that fits in a USB port, close in the sprint is the retro nokia
This is Wuzhi Hi-Fi class D amplifier which can output a maximum of 100watts. This works on a voltage under 24volts and has a stable output.
A quick guide on how to setup and run the Pick N Place Wheel Web Application on the Raspberry Pi.
Now it is time to get start with my own designs of class D amplifiers. This is the base article to getting started with 2.1 Audio amplifier
This project is a work of art, in continuous development and exploration. Composed mainly of a chamber containing some ferrofluids.
Making a custom printed circuit board (PCB).
16 LED Controller Using 2 Shift Register 74595
The Light Badge is an electronic kit which utilizes an LDR to detect lowering light levels and light an LED once it gets dark.
Simple robot made from a flexible PCB.
94%-efficiency alternative lipo charger with USB-C as a drop-in replacement of TP4056 with USB-C based on the TI-BQ25302 IC
This project is about a tiny (8mm x 10mm) breadboard-friendly breakout board for NeoPixel LEDs which can be stacked and soldered.
Soil Moisture Sensor - Water Pump - Water Level Sensor - MOSFET - Circuit - Code
Listen to the music in a better and more efficient way with a Class D audio amplifier.
Robot made with motor controller, signal distribution, and servo controller board, it's controlled through the network.
Increase RepRap capabilities beyond fused filament fabrication to produce different parts like circuit boards, plastic parts, and ceramics.
Create your own GPS/GPRS device with the Grove-A9G sensor module. Features USB-C, mic/speaker inputs, SIM - SD card slots, and antenna ports.
Learn how to convert your circuit to PCB using Easy EDA!
A simple, reliable and energy efficient module to facilitate touchless operation.
Invensense MPU6050 is a sensor with inbuilt Accelerometer and Gyroscope sensor along with motion and fall detection capabilities.
A robot made with a PCB as the chassis.
A hands-on tour of KiCad with a very simple project
A project that strikes a balance between simplicity and innovation – a single-button game console.
When surge facilities are quickly built, typical hospital call systems cannot be installed. This $6, easy to build device is all you need.
In this tutorial, we will be going over how you can program a button to distinguish a long press versus a short press using a Wia Dot One.
