Why class D amplifiers are not used in professional circuit, how amplifiers work and why Class D amplifiers are more efficient.
Adafruit MintyBoost Kit v3 - How to solder?
A power supply that can deliver 100w from a fast charger the best and smallest possible solution for lab bench supply.
Hello everyone. I have news on the Particle shield front. I have developed and manufactured 3 different shields for the Particle.
This amplifier can only produce bass, only low frequency sound. The maximum output of 100Watt on a 4ohm load, let's build for your bass tube
In this video I will try to briefly explain how to build a complete device, as well as some of the more important features.
Pouring water in these cups will run the fan.
An LTspice simulation of overtemperature protection of a power BJT by a Vishay PTC sensing through hole component
Blinking 3W Power LED ON and OFF. This LED can be further used for illumination purposes.
Class D TPA3221 based Fully Assembled Amplifier board, It can output a max of 200W RMS on 2ohm load. The design is minimal and small.
A review of the Male-Female 200mm Jumper Wires Pack (Pack of 40) from Tayda Electronics.
It is an isolated synchronous buck converter that can generate multiple inverting outputs helpful in electronics applications.
Do more power-saving with the SAMD21 chip on the TinyScreen+!
On&Off Button and 6v Coin Cell Batteries Power Supply for Arduino Nano by Circle Electronic
Let's design a TLF for LED bulb driver circuit and for microcontroller separately. Get all the design calculation from here and DIY custom.
A battery charging module to charge 1s/2s cells, based on buck phenomenon.
Learn how to power your Raspberry Pi Pico W projects easily and flexibly with the MB102 Power Supply Module for a clean, reliable setup!
Ultra-Low Power Single push button ON/OFF controller based on ATTiny13/13A/25/45/85 for other microController and circuits application.
Use the nPM1100 EK and an nRF52840 to create a BLE project that can be easily charged and powered efficiently.
Open-source USB Type C PD board for 1S Lipo or Li-ion cell or cell with similar chemistry.
This amplifier can output a maximum of 100watts and capable to run a 10 inch subwoofer. It is based on high fidelity 7498 IC. Follow design
Battery Box is a handy battery pack that supports QC3.0 fast charging and can be used to power all sorts of 5V projects.
