Measure the light intensity in the room and output data to a web API.
Creating a digital to analog converter (DAC) 8-bit using resistor ladder (R-2R Ladder) and implemented it in Arduino Uno to create signals.
Using the library SoftSerial and doing the configuration of one 10-bit ADC pin.
Simple and inexpensive way to make such an instrument, with which we can measure resistances with a resolution of 1 milliohm.
Raspberry Pi can also be used in places without electricity. If you can monitor battery voltage, critical data can be saved.
Light up three different LEDs using pulse width modulation corresponding to different ranges of analog input voltages.
In this guide we will show you how to use the ADC on your Raspberry Pi Pico using MicroPython. We will also go over some of the basic concpt
Real-time charts are the most effective way to show IoT data.
Use the eTape Liquid Level Sensor on the MCP3008 8-Channel 10-Bit ADC with SPI interface.
How to convert from analog to digital signals and vice versa using simple Python on microcontrollers.
Receiving and sending the digital and analog signal through AD5669 interface with Arduino to detect the A/D pulses.
How to Use a Digital to Analog Converter Aptinex DA4C010BI
Make that industrial sensor remotely accessible without writing a single line of code.
This program demonstrates the use of reading an ADC Channel value and displaying it on an I2C 7-Segment Display
Playing with different resolutions and showing the results on an old analog oscilloscope.
A revamping of the Bright or Not project using the Microsoft ADC Bus provider for the MCP3008
In this project the ADP3450 Oscilloscope/Function Generator/Logic Analyzer has been used to analyze various signals.
This project walks through basic RF test measurements using the Zmod Digitizer with WaveForms from Digilent.
This is the first robot kit I purchased when I started my electrical engineering degree in 2013.
Created a basic oscilloscope using 2 ADC in interleaved mode up to 24 msps, or dual channel Oscilloscope. Also support X/Y mode.
Using XADC on ZYBO Z7-20 to digitize function generator signals, transfer via DMA, and plotting in MATLAB.
Boil Buddy uses a piezoelectric disc to sense vibrations in the pot as water boils and sends a text alert.
Unlock the full potential of PSoC 6 with MicroPython! Learn the simple steps to read ADC values, turning analog signals into digital data
This LTspice simulation shows how to model this NTCLE317 +/-0.5 °C accuracy thermistor used in a simple ADC circuit.
