Adjust the speed of your car!
At Coolest Projects 2018, we showcased the Wia platform with a facial recognition Ferris wheel!
With this example, we show how to control a Coil Winding Machine with the PTHAT.
I created a raspberry pi remote-controlled car using Blynk.
Control IKEA Bekant Desk sit/stand height with M5Stack Core2 using two Relay units and a ToF (time-of-flight sensor VL53L0x) unit.
Tangible Coding provides an opportunity for kids to become involved in programming with no screen used.
In this tutorial I'll show you how to control rotational angle of servomotor using potentiometer & Arduino, So let's get started.
In this tutorial, you are going to learn about Arduino L298N Motor driver module interfacing.
learn how to program Attiny84 with this custom Breakout board with ams1117 for basic level projects like blinking LED and stuff.
This motor driver is able to control a motor using PID by I2C. Taking precise control of a motor have never been so easy.
A lowcost multi-pressure, multi-speed massager with timer for Joint and muscular pain,
In Visuino, at the bottom click on the "Build" Tab, make sure the correct port is selected, then click on the "Compile/Build and Upload" but
A two-wheel robotics platform built on the Arty development board.
In this tutorial we will learn how to position or calibrate a servo motor, this is often useful in robotics where we need to center a servo
Vary the voltage to your LEDs, motors, and other electronics with high efficiency using PWM.
It's not Wall-e, But it looks like Wall-e a bit.
The PIDDYBOT is a small, open source balancing robot with the aim of teaching PID controls using a "hands on" concept.
Self-balancing two-wheel inverted pendulum robot with (not-so-well) tuned PID control parameters.
Build your first low cost 2-wheel mobile robot and understand how to design each robot structure with laser cutting technology.
Use your Calliope Mini to control a 2 wheel robot. This example is meant to get you started and shows how easy it is to control the motors.
If the temperature measured by DS18B20 is above the predefined threshold, it turns the fan on automatically unless the piezodisk is pressed.
Use a Raspberry Pi with Codesys to control motors attached to an Arduino Uno using the EtherCAT Arduino Shield by Esmacat (EASE).
A robotic tower crane made out of Lego Technic, Arduino boards, 3D printed parts, off-the-shelf DC gear motors, and addressable RGB LEDs.
The goal here was to make a High Power DC Motor driver with 4 L293D connected in parallel so it can provide 4A of current to DC Motor!
